LINCOLN CONTINENTAL WIPER MOTOR 1961-65

The long awaited and much needed Clean Wipe wiper drive for the 1961-65 Lincoln Continentals is finally here.  After lots of development and engineering we have managed to design a kit that will allow you to eliminate the stock hydraulic wiper motor and replace it with a 12-volt heavy duty electric motor.  Kiss all those hydraulic power steering hoses good bye and make room for your engine swap.  Ford did not give us much room to work with but the motor will fit in the original cavity area behind the engine protruding only slightly further forward than the original motor and requiring only a minor reshaping of the end of the stock linkage rod to install.  The standard kit comes with a 2-speed self parking motor, switch, wiring harness, drive arm, all necessary mounting hardware, and installation instructions.  You can upgrade to either the 2-speed washer switch or the intermittent delay switch for an upgrade price.  You will only receive one switch with the kit based on what switch you choose.  The switch will have to be relocated in the dash as the original switch was a unique slide switch to operate the original hydraulic motor and has not been replicated at this time.  We recommend you leave the original switch in place.  If you choose to mount your switch in a tight or crowded area behind the dash you can add a shaft extension to the switch and it will allow you to push the body of the switch further back. Also available (add on) is wiper blades and arms & switches - Blades come in several sizes. 6, 8, 10, 12, 13 or 15 inches.  - Arms Polished stainless 5/8" knurl (right and or left). Or Polished Stainless adjustable fits 1/2" knurl. - Switches Intermittent delay wiper switch